Missing hand throttle component(s)

Ian Donkin · Post by **Ian Donkin** » Mon Nov 29, 2004 9:27 pm

I decided that it was time to bring the hand throttle into play earlier today as it's not worked since I got my car however I am faced with (yet another) small challenge...

In the transmission tunnel, attached at 90 degrees to the hand throttle lever, is a metal dowel pin about 2" long with a circlip fitted at the end furthest from the throttle lever. Additionally a clamping piece is attached to the throttle cable, but there is nothing to connect the dowel pin to the clamping piece and therefore the throttle cable is inoperative.

I have had a good scavenge around the transmission tunnel, but all I found was grease, a few pieces of chocolate and peanut looking crumbs (I kid you not).

Has anybody got any ideas what the missing component looks like? Even better, has anybody got one of these that they are willing to let go?

Any assistance with this one would be greatly appreciated.

Lightweight_911 · Post by **Lightweight_911** » Mon Nov 29, 2004 10:17 pm

These might help:

Nick Moss · Post by **Nick Moss** » Mon Nov 29, 2004 10:29 pm

You are missing part 20, its a piece of white plastic, available for about £12

Ian Donkin · Post by **Ian Donkin** » Tue Nov 30, 2004 9:17 am

Thanks Andy, thanks Nick - part 20 is precisely what is missing.

I must get a monitor capable of displaying 1280 x 1024 and then I too can run the PET system!

Regards
Ian