finally got back to doing a bit more on the 912 , the last of the interior parts , was the rear parcel shelf , i priced a few second hand and nearly died so i templated my ole one on to hard board, marked wher the suit case strapps where and cut out the pieces , and then marked wher it folds arounds , here i marked 2 lines and sliced it into 3 pieces , lelft 2mm gaps and bridged with some duck tape , then run duck tape from one end to the other both sides this made the hindge so it folds around the shelf , then of to be upholstered , owen nw
finally got the 912 in to the garage restoration starts here
Moderator: Bootsy
-
- DDK slapper chatter
- Posts: 459
- Joined: Thu Feb 14, 2008 1:56 pm
- Location: derry northern ireland
Re: finally got the 912 in to the garage restoration starts
ask me do i care. do i f**k
-
- DDK slapper chatter
- Posts: 459
- Joined: Thu Feb 14, 2008 1:56 pm
- Location: derry northern ireland
Re: finally got the 912 in to the garage restoration starts
heres it done and all for £30
ask me do i care. do i f**k
-
- DDK slapper chatter
- Posts: 459
- Joined: Thu Feb 14, 2008 1:56 pm
- Location: derry northern ireland
Re: finally got the 912 in to the garage restoration starts
ask me do i care. do i f**k
Re: finally got the 912 in to the garage restoration starts
Hi ive just seen your thread recently loved it read all of it. I'm about to start some on mine new wings and cills and a few more things. Great to see one in northern ireland i'm often over there so i'll keep my eyes peeled for you. Keep up the good work
paul
paul