finally got the 912 in to the garage restoration starts here
Moderator: Bootsy
-
- DDK slapper chatter
- Posts: 459
- Joined: Thu Feb 14, 2008 1:56 pm
- Location: derry northern ireland
when this 912 came it had the 1600 twin portvw van engine in it , as i can t afford the porsche one ill go with what i have , so took it down to a mate dave whetley ie caddy in dungannon to have it checked over , got it going no bother as it was runniing when it came , topped up oil , put on a petrol pump, robbed , and coil , it fired up , on stripp down it soon was realisied that all wasn t as seemed , 2 pots had broken finns , one was blowing to one side , so dave stripped on , it need s new crank, bearing , heads are perfect just needs valves reground , gasket set pistons pots barrels etc , and what ever he has to do . so i have all the tin ware down for blasting , and painting , have a noisey , so many looker s no comments ?
ask me do i care. do i f**k
-
- DDK slapper chatter
- Posts: 459
- Joined: Thu Feb 14, 2008 1:56 pm
- Location: derry northern ireland
have now fitted last of the carpet , also 2 second hand sunvisors , fed all the wiring out for the front back lights also refurbished the horns and fitted wired them , recut new fuel line for the petrol tank , fitted seat belts , wax oiled in and around all the light appatures , slowly getting there owen nw
Last edited by owen nw on Tue May 17, 2011 9:41 pm, edited 1 time in total.
ask me do i care. do i f**k
-
- DDK slapper chatter
- Posts: 459
- Joined: Thu Feb 14, 2008 1:56 pm
- Location: derry northern ireland
got the front bumper assembled with my nw overidders thanks nick .
lots of futtering about with the new bumper to car seal ,
then assembled the 4 piece rear bumper greasen and wax oiling everything as i went , then took the car out and turned it round for more room and fitted the refurbished drive shafts , tidyed up a few bits , and am now ready to fitt the engine , owen nw
lots of futtering about with the new bumper to car seal ,
then assembled the 4 piece rear bumper greasen and wax oiling everything as i went , then took the car out and turned it round for more room and fitted the refurbished drive shafts , tidyed up a few bits , and am now ready to fitt the engine , owen nw
ask me do i care. do i f**k