Page 1 of 1
Non Parking Wipers '72 car
Posted: Thu Jan 12, 2006 6:46 pm
by Andre
Hi,
My wipers work well enough but they dont self park, its not the stalk as I changed that, an ideas welcome.
Thanks
Posted: Thu Jan 12, 2006 6:50 pm
by Nige
could be the relay, but if its similar to a VW wiper motor inside the motor/gear unit itself there is a blade like contact switch that often gets dirty corroded or bent out of action, that may be the problem
Posted: Thu Jan 12, 2006 7:05 pm
by Andre
Nige,
Thanks, will take a look at the relay, if not looks like a wiper motor strip...
Andre
Posted: Thu Jan 12, 2006 7:34 pm
by Gary71
Mine never park either, I'm just a master of the art of timing turning them off now!
Posted: Thu Jan 12, 2006 8:20 pm
by Nige
Andre
Just quoting the Haynes 911 manual
Sympton:
Motor runs when switched off, or will not park blades in the correct position
Possible fault:
Contacts in cover faulty. Earth wire from terminal 31b to switch an earth faulty.
Doesn't show any pictures or diagram
Posted: Thu Jan 12, 2006 10:56 pm
by Andre
Nige, Many thanks again. I have been suspecting a few earth problems as I am getting a few spurious electrical gremlins. Thanks again for pointing me in the right direction.
Its funny, but as Gary states, you get a nack of parking the wipers youself, it almost becomes a challenge to get them parked as low down as possible!
Thanks again.
Andre
Posted: Fri Jan 13, 2006 7:57 am
by Gary71
They just won't park at over 90mph! I end up sticking them over on the passenger side to get them out of the way
Posted: Sun Jan 15, 2006 11:31 am
by 1972_911t
I had the same problem, theres two electrical connectors inside the motor that tell it where the rest position is on of them had worn down so I just put a spot of soilder on it and sanded it flat, worked perfect ever since, took 2 hours of my time much cheaoer than the 100+ for a new motor!
Steve
Posted: Mon Jan 16, 2006 10:41 am
by Andre
Again, many thanks!