DDK - Die Deutschen Klassiker

Hi, does anyone know the size of the C spanner required for the front shock / strut nut- the one that secures the shock into the strut.

Thanks Danny

Boge ?

Koni shocks - fitted new shocks a few months back now. All good but the nut securing the shock into the strut came loose, re fitted and tightened but has come loose again - shock is knocking on the strut. May have to lock tight it this time and use the correct tool (believe this is a c spanner

Pretty sure it’s 24mm but I’m not with the car right now. I can check this evening.
As for tightening you are supposed to hold the centre shaft still with a tiny little Allen key… but 99% of the time you hand tighten the nut then bang it home with an air gun…
Not had one come loose and loctite sounds like a bad idea as if the damper shaft starts spinning when you need to undo it then it’s a world of pain.

Thanks for the reply - it’s not the 24 mm but it’s the large flat disk type nut that secures the shock into the strut / shock housing.

Danny

Do you have a pic?

I’ve now got bilsteins struts and shocks which are inverted and use a roll pin to locate the shock into the strut at the bottom

But With my old Boge that had a similar set up to you , ultimately I used a monkey wrench .. which admittedly is a bit ham fisted way of tightening that disco

How To - Bilstein Suspension Upgrade / Boge struts
https://r.tapatalk.com/shareLink/topic? ... source=app