Page 4 of 4
Re: lightweight sleeper build
Posted: Sat Feb 17, 2024 12:15 am
by coomo
fuel lines.For these I silver soldered fittings into stainless tube.Then inserted into
acesss.Did get a bit tough as it progressed through tunnel!
Re: lightweight sleeper build
Posted: Sat Feb 17, 2024 7:52 am
by 911hillclimber
Great build, but if i may:
The rear flex hoses go through the cast tab where the factory flex hose meets the hard pipe to the calipers normally.
Will you bush that hole to protect the hose?
I think this is a dry build you are going through at this stage.
Sorry if you have this covered already.
Re: lightweight sleeper build
Posted: Sat Feb 17, 2024 9:46 am
by stretch
Good work Paul, looking very sharp.
Re: lightweight sleeper build
Posted: Sat Feb 17, 2024 10:57 am
by coomo
911hillclimber wrote: ↑Sat Feb 17, 2024 7:52 am
Great build, but if i may:
The rear flex hoses go through the cast tab where the factory flex hose meets the hard pipe to the calipers normally.
Will you bush that hole to protect the hose?
I think this is a dry build you are going through at this stage.
Sorry if you have this covered already.
Thanks.These lines are braided(long),not factory lines, there is no hard line,they run directly from the junction thingy, to caliper.There is a bush that fits the hole.IIRC Rebel Racing again.
Re: lightweight sleeper build
Posted: Sat Feb 17, 2024 10:58 am
by coomo
stretch wrote: ↑Sat Feb 17, 2024 9:46 am
Good work Paul, looking very sharp.
Thanks Dave.