DDK - Die Deutschen Klassiker

Anyone have any recommendations for UK machine shops that can deal with Porsche cases/heads?

I've found these guys in Holland (http://www.ahnendorp.com/porsche2.html) but can't find anyone in the UK, just trying to price a few things up...

You could try these altho I have no experience other than Stateside is a very busy shop.

http://www.statesidetuning.co.uk/

http://www.laperformance.co.uk

Ahnendorp did all my machining years ago, I went there, but the head work was not too good (valve seat came loose) I had a dodgey camshaft off him and a timing gear stamped with the wrong reference point.
Having said that he was a nice guy, but he would be as he was taking my money.

There is Klaus also in Germany

Thanks Pablo!

What do you need done. I have one place that does cranks, another for heads

Luke I have a contact in Ringwood for the cranks I will try and dig out the number. Saunders I think they are called I will speak to my mate later next week.

I would ask if he does 911's though, I know he has done flat 4's.

M

Ringwood be handy!

I only need case and head work though, crank and cams are fine

I have used stateside and found them to be very good and quick when I had my heads done on the 14. Although when the heads were delivered back to me I was not expecting to find swarf left on them!! (I would note that i did only have the seats done and I was fitting new valves so guess if I had had the whole lot done it would have been cleaned etc)

david

Luke give Alex a ring at retro i know he has used me thinks

but i would make sure he has done this sort of work before though.Machine guy..


Mark

Owslebury Crankshafts in Winchester have done 914 and 911 valve guides and seats for me, quick service and not expensive, I'm not sure if they do case machining. I use Bassett Down Balancing near Swindon for - surprisingly - balancing.