Page 7 of 20
Posted: Tue Sep 05, 2006 3:41 pm
by Gary71
OK cheers. Sorted!
Posted: Wed Sep 13, 2006 4:26 pm
by Gary71
Finished the wiring!!!!!
Well most of it, I still need to do the detail of the connectors in the engine bay, but I'm leaving that until the harness is in place so I can get the lengths spot on.
I've made it in three sections for ease of assembly and built in a bit of redundancy in some extra cables for 4 wire Lamba sensor, PWM fast idle valve and some other bits I'm not going to use just yet.
Just need to fit it to the car now
Posted: Wed Sep 13, 2006 7:43 pm
by Ian Donkin
Fancy making another one
.
Posted: Wed Sep 13, 2006 7:46 pm
by Gary71
No.
Posted: Wed Sep 13, 2006 7:46 pm
by Gary71
No.
Posted: Wed Sep 13, 2006 7:48 pm
by Gary71
Double post
Clearly I meant it
You are welcome to the wiring diagram and stick drawing with all the measurements on though
Posted: Wed Sep 13, 2006 7:50 pm
by Mick Cliff
Come on Gary - don't mince your words
Ian needs something to act as a calalyst to get his project going
Posted: Wed Sep 13, 2006 7:52 pm
by Gary71
He's from Yorkshire, he'll understand
Spade is a spade and all that
Come on Ian, pull your finger out and get the fuel injection on!!!
(how's that?
)
Posted: Wed Sep 13, 2006 7:52 pm
by Mick Cliff
Posted: Wed Sep 13, 2006 7:54 pm
by Ian Donkin
Posted: Wed Sep 13, 2006 7:54 pm
by Ian Donkin
And my manifolds.
Posted: Wed Sep 13, 2006 7:58 pm
by Gary71
So run it in on the carbs then put the EFI on...
Remember to put a lambda sensor boss in your new heat exchanger before you bolt them on. Then you can get rid of the old ones (hint
)
Posted: Wed Sep 13, 2006 8:05 pm
by Mick Cliff
Yeah, what Gary says. Come on Ian, get your finger out!
Posted: Wed Sep 13, 2006 8:23 pm
by Gary71
My Dad (an electrical engineer) just sent me this comment:
"The beauty of electrical engineering is if you make a mistake it stops working for ever and you have no idea why. It may catch fire just to give you a clue where it failed, but still will not work...."
Nice.
Posted: Wed Sep 13, 2006 10:49 pm
by Barry
