DDK - Die Deutschen Klassiker

Don’t leave it six years again to update us!

Superb car

Way to go Dougie, an utterly glorious car and an absolute peach of an engine

I know it's been a long time but sure sounds like it's worth the wait, congrats

Now drive it hard and enjoy

Mick Cliff wrote:
What's next Dougie?

Hi Mick,hope your well?

A few other things to finish on the rep first, before any other projects will be considered

Bootsy wrote:Don’t leave it six years again to update us!
Superb car

Thanks Thomas.

Darren65 wrote:Way to go Dougie, an utterly glorious car and an absolute peach of an engine
I know it's been a long time but sure sounds like it's worth the wait, congrats
Now drive it hard and enjoy

Cheers Darren, there were a few low,(and expensive), points along the way,but once you get back in the driving seat,
they become a distant memory, as you well know yourself

Good to see, hopefully Mike can now concentrate on my engine

brembo wrote:

mrg3.6 wrote:Well done Dougie
I was almost shaking with excitement the first time I drove my car home that was of course before it broke down
By the way have you installed guard under the plastic tank - if so any photo's?
Thx
MArtin

Here's some photo's of tank guard Martin.









Regards,

Can I ask where you got your tank guard from?
Looking to fit one to mine.

Thanks,

Stuart

Got mine from Chris at Fennlane

Fenn Lane also

stuarts wrote:

brembo wrote:

mrg3.6 wrote:Well done Dougie
I was almost shaking with excitement the first time I drove my car home that was of course before it broke down
By the way have you installed guard under the plastic tank - if so any photo's?
Thx
MArtin

Here's some photo's of tank guard Martin.









Regards,

Can I ask where you got your tank guard from?
Looking to fit one to mine.

Thanks,

Stuart

Stuart,got it from Mike at mb.engineering@btconnect.com .

Great to see the car again Dougie, brings back wonderful RSR memories!

brembo wrote:Front anti roll bar. will try 16mm bar to start with.



Mikes drawing sent to manufacturer to make up brackets, to weld to inner wing.






Arb fitted.

Mike Bainbridge fitted front arb to my rep.He manufactured the strengthening brackets for the inner wing.Handy source if you need some made up.

Sorry,posted this in the wrong place

Nice